Bład P1517 Citroen 2.0 Hdi

Bład P1517 Citroen 2.0 Hdi. However it just wouldnt go, just kept turning over. Pb moteur 806 hdi code p1517 et p0191.

Despiece Citroen Xsara Break (N2) 2.0 HDI 90 (90 cv) 2003
Despiece Citroen Xsara Break (N2) 2.0 HDI 90 (90 cv) 2003 from www.despiecesde.com

Stop requested but regulator still active. Repair of your citroen engine control unit edc15c2. The biggest problem is the engine ecu is locked and i am not able to progress from there to find if the hp pump or a sensor is damaged.

Renault Trafic X82 1.6 Dci;

A list of opel vauxhall renault cars using nox sensors: I bought my van and found a wekk later the head gasket had gone as it was pushuing out water from the expansion tank and the low water light kept coming on. The van wasnt used for a few weeks, then one morning i went to start it and the battery had run flat so i used some jump leads in attempt to get it going.

Ok I Have A Peugeot Expert 2.0 Hdi With Running Problems So Heres My Story.

I have tested solution of immotool but persist dtc p1517. Pries uzgestant dar parase ant borto kompo gearbox fault. P0102 mass or volume air flow circuit low input.

23 Posts • Page 1 Of 1.

Thanks man i tried to install sedre :s and search the part number of the sensor :s the vin number is vf7larfkc6y501635, i use diagbox 7.02 (clone interface) and. P2562 voyant moteur citroen c3 picasso bonjour, j'ai une citroen c3 picasso et depuis un bon moment j'ai un voyant moteur orange qui s'affiche et qui me marque faite rparer le vhicule.je suis all voir un garage citroen donc il a mis la balise et a pu voir le code default qui est la p2562. The car was not used for a long time and then would not start.

Vaziuojant Pradejo Kalenti, Po Kokio 1 Km Nukrito Apsukos Ir Uzgeso.

I am not sure of the cause of the fault. P0103 mass or volume air flow circuit high input. A list of citroen and peugeot cars using nox sensors:

However It Just Wouldnt Go, Just Kept Turning Over.

Sveiki, sendien gryztant is darbo atsitiko tok dalykas. Je viens de passer le diag pp2000 sur mon 806 hdi 2l type rhz suite à l'allumage du voyant diagnostic et je me retrouve avec 2 défaut dont voici les copies d'écran. Sur un berlingo 2l hdi 90cv, j'ai 2 défauts chiants qui m'empêchent de démarrer après un changement pompe hp (bosch occas casse).

Leave a Reply

Your email address will not be published. Required fields are marked *